Rubberized Fibered Coating Français
This excellent asbestos free rubberized fibered coating CR-340 is formulated with special fibers and elastomers to waterproof wood, masonry and asphalt roofs. It can also be used to regenerate damaged surfaces or to re-saturate asphalt and felt roofs.It regenerates deteriorated surfaces and improves service life of roofs. This is the perfect product foundation coating And act as a waterproof membrane.
Surface Preparation
Don't apply if rain is foreseen. Surfaces must be sound, clean and free of dust, dirt, rust, oil, grease,chipped paint, frost or any other contaminants. Prevously fill holes, cracks and weak spots with CONDOR’s rubberized plastic cement CR-320.
Stir well before use. Apply with a squeegee, a brush, a roller or a paintbrush.To ease application in cold season, keep product in a warm place.
The penetrating oils contained in this product allowes it to stay smooth and sticky for a certain period of time depending on weather conditions.
Clean tools and equipment with mineral spirits.
CAN/O.N.G.C. 37.8M89
Available in 3.78 L and 18.9 L.
Shelf Life
This product can be conserved in its original container, tightly sealed, up to 12 months after purchasing date by the applicator.
Technical Data Table
Color Black
Solids by Volume 60 to 70 %
Weight 0,93 kg/L (7,8 pounds/gal)
Coverage 3,78 L/ 18,5 m² (5 gal/200 ft²)
Dry Time*

To 50 % R.H. 20°C (68°F)

To the Touch* 4 hours
Completely Dry* 48 hours
Service Temperature Maximum: 85°C (185°F)
Application Temperature 10°C and more
Chemical Resistance

Resistant to water calcium chloride, salt and to lightly acid or alkaline solutions. Do not resist to oils, greases and solvents.

Permeance to Water Vapor (ASTM E96) Layer of  3 mm (1/8'') before dried 1,2 ng/Pa.m².s (0,02 perms)

* Drying Time depend of surface porosity and temperature.

Never use on tar-based products. Do not apply on roofs with slope higher than 4/12 or on metal roofs. Resaturating agents must be covered with CR-80 aluminum paint. If product is applied near a ventillation unit or an air conditioner, take necessary precautions to avoid infiltration solvent odor inside. Protect freshly applied product and open container from open flame and adjacent welding activity. If it use as foundation coating, let dry completely before covering or back fill to avoid prematurely product deterioration that could cause humidity infiltration. For EXTERIOR USE only.
10 years limited warranty when installed and / or applied as recommended by the manufacturer. We will replace the product with a manufacturing defect. Under no circumstances will the manufacturer be liable for any amount in excess of the purchase price of the product used. The consumer must ensure that this product is suitable for the intended use. Because of atmospheric conditions, applicator competence and surface conditions being independent of the manufacturer's control, we limit our liability for one year following the date of purchase, with proof of purchase, to replacement of defective material only in its original hermetic container. Port paid factory (FAB factory).

Rubberized Fibered Coating
Rubberized Fibered Coating
Sans Amiante
Avertissement Simdut Simdut

CONTENTS MAY CATCH FIRE: Contains petroleum distillates. May cause dizziness, headache or nausea. May cause nose, throat, eyes and skin irritation. Keep away from heat sources, sparks and flames. Do not smoke. Use only with adequate ventilation. Do not breathe vapors. Wear safety glasses and appropriate gloves. KEEP OUT OF REACH OF CHILDREN.

FIRST AID TREATEMENT: Eyes : In case of contact, flush immediately with plenty of water for at least 15 minutes and get medical attention immediately; for skin, wash thoroughly with soap and water. If you experience difficulties in breathing, leave the area to obtain fresh air. If difficulties continues, get medical assistance immediately. If swallowed, do not induce vomiting. Get medical attention immediately.
PDFdownload PDF version