Rubberized Foundation Coating Français
This excellent rubberized foundation coating CR-360 for dry surface contains elastomers. It is formulated to waterproof concrete, masonry and wood structures. It is formulated to resist against bad weather. It offers flexibility as well as ease to apply. It becomes a strong waterproofing flexible coating once dry.
Surface Preparation
Don't apply if showers are foreseen. Surfaces must be sound, clean, free of dust, loose gravel, dirt, rust, oil, grease, chipped paint, frost or any other contaminants or foreign materials. At first on a new foundation, seal the joint between footing and foundation wall with a bead of rubburized plastic cement CR-320. To fill holes, cracks and weak spots; use the same product. You can also use the Fondafix that is the perfect product to smooth over wall imperfection.
Stir well before use. Apply only on dry surfaces. Apply on foundations uniformly with a brush, a paintbrush, a roller or a spray gun. To ease application in cold season, keep product in a warm place.
Clean tools and equipment with mineral spirits.
CAN/O.N.G.C. 37.GP-6MA
Available on 3.78 L and 18.9 L.
Shelf Life
This product can be conserved in its original container, tightly sealed, up to 12 months after purchasing date by the applicator.
Technical Data Table
Color Black
Solids by Volume 50 to 60 %
Weight 0,91 kg/L (7,6 pounds/gal)
Coverage 1,0 to 2,0 L/m² (2 to 4 gal/100 ft²)
Dry Time*

To 50 % R.H. 20°C (68°F)

To the Touch* 4 hours
Completely Dry* 48 hours
Service Temperature -30°C to 95°C (-22 to 203°F)
Application Temperature Can be applied at low temperature but preferably above 10°C (50°F). Thickens at low temperature.
Chemical Resistance

Resistant to water calcium chloride, salt and to lightly acid or alkaline solutions. Do not resist to oils, greases and solvents.

Permeance to Water Vapor (ASTM E96) 3 mm (1/8'') coat before drying 1.2 ng/Pa.m2.s (0.05 perms)

* Drying Time depend of surface porosity and temperature.

Let dry completely before covering or back fill to avoid prematurely product detoriation and cause humidity infiltration. If product is applied near a ventillation unit or an air conditioner, take necessary precautions to avoid infiltration solvent odor inside. Protect freshly applied product and open container from open flame and adjacent welding activity. For EXTERIOR USE only.
10 years limited warranty when installed and / or applied as recommended by the manufacturer. We will replace the product with a manufacturing defect. Under no circumstances will the manufacturer be liable for any amount in excess of the purchase price of the product used. The consumer must ensure that this product is suitable for the intended use. Because of atmospheric conditions, applicator competence and surface conditions being independent of the manufacturer's control, we limit our liability for one year following the date of purchase, with proof of purchase, to replacement of defective material only in its original hermetic container. Port paid factory (FAB factory).

Rubberized Foundation Coating
Rubberized Foundation Coating
Sans Amiante
Avertissement Simdut Simdut

CONTENTS MAY CATCH FIRE: Contains petroleum distillates. May cause dizziness, headache or nausea. May cause nose, throat, eyes and skin irritation. Keep away from heat sources, sparks and flames. Do not smoke. Use only with adequate ventilation. Do not breathe vapors. Wear safety glasses and appropriate gloves. KEEP OUT OF REACH OF CHILDREN.

FIRST AID TREATEMENT: Eyes : In case of contact, flush immediately with plenty of water for at least 15 minutes and get medical attention immediately; for skin, wash thoroughly with soap and water. If you experience difficulties in breathing, leave the area to obtain fresh air. If difficulties continues, get medical assistance immediately. If swallowed, do not induce vomiting. Get medical attention immediately.
PDFdownload PDF version