Eagle Grout Prestige Premixed Ceramic Grout Français
EAGLE GROUT PRESTIGE is an high performance one component water-based, urethane and quartz pre-mixed grout for ceramic tiles and natural stones. Ready-to-use, it has been formulated for interior ceramic tiles grouting, horizontally or vertically. This non-toxic, odorless and non flammable products gives a very good
Surface Preparation
Ceramic tile thin-set mortar must be dry prior to grouting. Make sure that joints are clean, dry, free of dust or dirt, etc. Natural stone or very porous tiles, absorbent or rough could require surface sealant application prior to grouting, seek for tile supplier advises. Some glazed tiles or natural stones could be scratched or damaged by aggregates contained in this product. Consult tile supplier. It is important to make sure that setting material is dry and joints are emptied from dust, dirt and debris.
In case of doubts, do a test on a small hidden portion of floor before use. Ambient surface and product temperature must be superior than 10ºC (50ºF)and lower than 35ºC (95ºF) during the installation and for the first 24 hours. Most convenient temperature is between 20ºC and 22ºC. Spread Eagle Prestige Grout diagonally from joints with a rigid rubber float having a 45º angle. Uniformly compact grout into joint making sure there are no voids or air pockets. Remove excess grout by passing rubber float diagonally from joints at an angle of 90º. This method makes a joint filled equal to tiles and leaves tile surfaces mostly clean. Place correctly and clean joints and tiles carefully after about 30 minutes of drying, with a nylon scrubbing pad and warm water. Take care to remove cleaning debris to prevent them from being integrated back in joints. Eliminate all remaining water from joints surfaces with a firm cellulosic sponge to optimise a good material cure.
Ready to use. It could be preferable to do a small remixing to eliminate compaction due to transportation. Proceed immediately to apply and finish. Close lid between each uses to prevent product from drying.

Approximate coverage for 4 L pail: Thin joints : …………..about 6 to 7 m² (65 to 75 ft²)

Protect surfaces for 48 hours. Curing time may vary according to temperature and humidity level. Make sure application is dry prior to allow light traffic
Clean working tools and hands with water while product is still fresh.
Available in 4 L pails.
Store in a dry and fresh area. KEEP FROM FREEZING. Shelf life is 12 months in its original non-opened.
Technical Data Table
Minimum time limits before finishing and cleaning sponge 10 to 15 minutes
Time limits before light circulation 24 hours
Final Cure 7 days

* Drying Time depend of surface porosity and temperature.

The customer shall verify of the suitability of this product for the intended purpose. Applicator's skill, weather and surface conditions being beyond manufacturer's control, we limit our liability to replacement of defective material only in sealed container, within 1 year of proof of purchase. FOB plant.

Eagle Grout Prestige
Eagle Grout Prestige
Eagle Grout Prestige

Brochure with color samples

Warning Simdut

MAY IRRITATE EYES AND SKIN. Do not get in eyes, on skin or on clothing. Keep out of reach of children.

FIRST AID TREATMENT: Contains Stoddard solvent. If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, clean with mineral oil followed by soapy water then rinse well.
PDFdownload PDF version