Eagle Kit PDF Cracks Bridging Kit Français
Description
Eagle Black’s crack bridging kit includes an elastomeric latex coating and a polyester mesh reinforced canvas. Ideal to repair and prevent cracks on cement backer joints or on concrete either inside or outside before the application of finish products. Recommended to joint plywood seems, internal use only. This concrete-grey colored water-based coating is an 100% acrylic emulsion that will give flexible and resistant finish. It is an excellent product to waterproof cement backer panels and joints for ceramic shower. This waterproofing membrane can considerably reduce humidity problems caused by hydrostatic pressure.
Surface Preparation
All surfaces to be covered shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles. They must also be exempt from any trace or presence of acids, concentrated alkalis, chemical cleaning agent or any other material that can reduce adhesion. All concrete substrates shall be completely cured and at least 28 days old and they must be roughened for a good adhesion. Preferably repair cracks larger than 6 mm (1/8”) with an Eagle Black’s concrete repair product. The only recommended wood substrate is an exterior grade plywood installed inside on floors in dry areas. Ambient surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) before the installation and for the first 24 hours.
Application
Apply a generous coat of elastomeric latex on each side of the crack to repair or bridge, unroll and insert mesh in the coating, apply a second coat of latex over the mesh. For waterproofing, it is recommended to apply two separated coats of products to ensure a thickness of 12 to 15 mil The elastomeric membrane can be used without mesh when there is no crack or just micro-cracking.
Yield

3.78 L of crack bridging kit can cover up to 5.6 m² (60 ft²). Reinforcement mesh has in length 18.3 m (60 ft) and 15.2 cm (6 inch) width. Coverage rate and drying time are dependent of surface porosity and temperature.

Package
Available in 3.78 L pail with 80 ft of polyester mesh.
Storage
Keep from freezing. This product can be stored in its original non-opened container for 12 months after purchasing date.
Technical Data Table
Color Concrete Grey
Solid content 66 to 68%
Density 1,4 kg/L (14 pmd/gal)
PH 8.5 to 9.5
Coverage 3,2 m² (34 ft²) to 0.76mm (30 mil or 1/32”) thickness
Drying time To 50 % H.R. 20° C (68° F)
To the toutch 2 hours
Completely dry 4 hours
Service température - 40° C to 90° C (- 40° to 195° F)
Application temperature minimum 10° C (50° F)
Chemical resistance Resist to most popular acids, alkalis, greases and solvents
Permeance to water (ASTM E96) Permeable
Permeance to rupture (ASTM D412) 350%
Strength at rupture (ASTM D412) 560 kPa (80 PSI)
 

* Drying time depends on application method, temperature and porosity surfaces

Warranty

Eagle Kit PDF
Eagle Kit PDF
Ecologic
Warning Simdut

MAY IRRITATE EYES AND SKIN. Do not get in eyes, on skin or on clothing. Keep out of reach of children.


FIRST AID TREATMENT: Contains Stoddard solvent. If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, clean with mineral oil followed by soapy water then rinse well.
 
PDFdownload PDF version