Eagle Patch Plus High Performance Acrylic Additive For Eagle Patch Français
Eagle Patch Plus is a 100% acrylic latex specially formulated to be used with Eagle Patch to raise adhesion performances on hard-to-adhere surfaces. This product improves characteristics of Eagle Patch such as adhesion and durability over old residues of cut back adhesives, asbestos or composite vinyl tiles, ceramics, linoleum and non-cushion vinyl sheeting previously prepared.
Surface Preparation
All surfaces shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles, acids, alkalis or any other material that could reduce adhesion. The only recommended wood substrate for floors is new exterior grade plywood installed on interior floor in dry areas. All concrete substrates shall be completely cured and at least 28 days old. They must be roughened for better adhesion. Ambient surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) during application and for the first hour.
Stir well before use. Eagle Patch Plus is ready to use; do not dilute. In a clean container, pour exactly 380 ml per kilogram of Eagle Patch Plus and gradually add Eagle Patch powder while mixing with a low-speed drill and a mixer. Blend for 1 to 2 minutes scraping recipient walls and paddle to obtain a homogeneous trowelable consistency. Spread immediately to the desired texture and finish. Mix portion of product that can be applied in less than 15 minutes.
Eagle Patch mixed with Eagle Patch Plus takes about 60 minutes to dry. Curing time may vary according to temperature and humidity level. Make sure application is dry prior to allow light traffic for floor covering installation.
Clean working tools and hands with water while product is still fresh.
This product is available in 3.78 L, 10 L and 18.9 L containers.
Store in a dry and fresh area. Keep from freezing. Shelf life is 12 months in its original non-opened container.
Technical Data Table
Polymer type 100% Acrylic
Appearance Milky white
Odour Light ammonia odour
Density ASTM C-185 1.01 kg/L
PH 8.6
Coverage per 3.78 litre of product mixed with 10 kg of Eagle Patch 3.07 to 3.44 m² (33 to 37 pi²) @ 3 mm thickness (1/8”)

* Drying Time depend of surface porosity and temperature.

The customer shall verify of the suitability of this product for the intended purpose. Applicator's skill, weather and surface conditions being beyond manufacturer's control, we limit our liability to replacement of defective material only in sealed container, within 1 year of proof of purchase. FOB plant.

Eagle Patch Plus
Eagle Patch Plus
Warning Simdut

MAY IRRITATE EYES AND SKIN. Do not get in eyes, on skin or on clothing. Keep out of reach of children.

FIRST AID TREATMENT: Contains Stoddard solvent. If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, clean with mineral oil followed by soapy water then rinse well.
PDFdownload PDF version