Eagle Prime Plus Concrete Polymer Adhesive Français
Description
Eagle Prime Plus is a 100% acrylic latex specially formulated to prime old concrete or wood surface to improve adhesion of a repair mortar. Use Eagle Prime Plus as primer is a good alternative to concrete water saturation. It can also be added partially or totally in replacement of water in most non polymer modified basic concrete or mortar mix. This addition will improve some characteristics such as adhesion and long lasting durability.
Surface Preparation
Avoid working under intense sun. All surfaces shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles, acids, alkalis or any other material that could reduce adhesion. The only wood substrate recommended is new exterior grade plywood installed on interior floor in dry areas. All concrete substrates shall be completely cured and at least 28 days old. They must be roughened for a better adhesion. Ambient surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) during application and for the first hours.
Mixing
Stir well before use. Eagle Prime Plus is ready to use; do not dilute. For very porous substrate, it could be necessary to apply two coats . Apply a generous coat with a brush or a roller.
Curing
A repair mortar must be applied while latex application is still humid, without any accumulations. If primer has partially dried, proceed with another application. Curing time may vary according to temperature and humidity level. Protect surface against rain, sun and wind.
Cleanning
Clean working tools and hands with water while product is still fresh
Package
This product is available in 3,78 L, 10 L and 18,9L containers.
Storage
Store in a dry and fresh area. Keep from freezing. Shelf life is 12 months in its original non-opened container.
Shelf Life
Keep from freezing
Technical Data Table
CARACTERISTICS EAGLE PRIME PLUS
Polymer type 100% Acrylic
Appearance Milky white
Odour Light ammonia odour
Density ASTM C-185 1.01 kg/L
PH 8.6
Covering rates for a receipe of 4 liters
20 m² (212 ft²)
 

* Drying Time depend of surface porosity and temperature.

Warranty
The customer shall verify of the suitability of this product for the intended purpose. Applicator's skill, weather and surface conditions being beyond manufacturer's control, we limit our liability to replacement of defective material only in sealed container, within 1 year of proof of purchase. FOB plant.

Eagle Prime Plus
Eagle Prime Plus
Ecologic
Warning Simdut

MAY IRRITATE EYES AND SKIN. Do not get in eyes, on skin or on clothing. Keep out of reach of children.


FIRST AID TREATMENT: Contains Stoddard solvent. If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, clean with mineral oil followed by soapy water then rinse well.
 
PDFdownload PDF version