Nos produits

Aquavernis

AQUAVERNIS is a gloss varnish made from an aqueous dispersion of aliphatic urethane. Designed as a protective layer for hardwood floors, this product is highly resistant to wear, water, alcohol and common household products. It is virtually odorless in addition to dry in a few hours. This varnish does not yellow and is easy to maintain. Its milky color at the time of application facilitates its installation and turns into a beautiful glossy finish completely transparent.

Would you buy this product?

FIND A RETAILER

Advantages

  • Dry quickly
  • Keeps the color of the wood
  • Ecological
  • Low odor
  • Low toxicity and safe for health
  • Low in VOC
  • Applies easily without mask

Documentation

Categories: , Tag:

Use

Function

Varnish

Building components

Floor

Surface

Hardwood floor

Covering rate

7.9 to 14,7 m2/L (320 to 600 ft2/gallon)

Color

White

Preparation / Application

Application temperature

15°C to 35°C Best conditions : 25°C et 50% H.R.

Application tools

Synthetic material as sheepskin type / Paint brush / Roll with the exception of foam rollers

Surface preparation

Sand the surface completely in the direction of the wood fibers with #80 coarse paper and then sand the surface with #120 fine paper until a smooth, even finish is obtained. All dirt and foreign matter must be removed with a vacuum cleaner, followed by a final cleaning with a pad moistened with Thiroco solvent to remove all traces of dust. It is recommended to use Thiroco Sealer100 as a primer.

Application

At the time of application, the temperature of the air and the substrate should be between 15°C and 35°C. Temperature and relative humidity are critical factors for proper drying. It is important to thoroughly mix the product before and during the application. Use only in well ventilated areas without drafts. Pour a small amount of varnish directly on the floor or into a paint tray and apply evenly with a brush, roller or pad. It is recommended not to apply this product in layers of exaggerated thickness. Allow a minimum of 2 hours of drying between each layer. Lightly sand the surface with #180 or #220 fine paper in the direction of the wood grain between each coat. Remove dust from sanding. For better durability, it is recommended to apply two coats of AQ100 in addition to Sealer100 or three coats of varnish if Sealer100 is not used.

Drying

If the coating dries properly under normal conditions (around 25°C and 50%RH), it is possible to walk on the floor after 24 hours. We recommend waiting 48 hours before replacing the furniture. Since the final properties of the coating are obtained after 7 days, do not lay carpets or clean the floor until the product has completely matured. The drying time depends on the application method, the temperature and the porosity of the surfaces.

Caution / Cleaning / Storage

Restriction / Caution

This product should not be used alternately with another product. It is not necessary to remove the food from the places of application. Do not place carpets and do not clean the floor before the product matures in about 7 days.

Cleaning

Water

Storage

Store this product away from frost. Store in a cool place between 15°C and 25°C. The product may be kept in its original sealed container up to 12 months after the date of purchase by the user.

Available format

3,78L / 18,9L

Warranty

The customer must ensure that this product is suitable for the intended purpose. The user assumes full responsibility for the results of an application in accordance with the instructions on this label. Atmospheric conditions, applicator’s skills and surface conditions being beyond the manufacturer’s control, we limit our liability for one year following the date of purchase, with proof of purchase, to replacement of defective material only in its original hermetic container. Port paid plant (FOB plant).